Antenna tuner
| Part of a series on |
| Antennas |
|---|
An antenna tuner, a matchbox, transmatch, antenna tuning unit (ATU), antenna coupler, or feedline coupler is a device connected between a radio transmitter or receiver and its antenna to improve power transfer between them by matching the impedance of the radio RF port (coaxial or waveguide) to the antenna's feedline. Antenna tuners are particularly important for use with transmitters. Transmitters feed power into a resistive load, very often 50 ohms, for which the transmitter is optimally designed for power output, efficiency, and low distortion. If the load seen by the transmitter departs from this design value due to improper tuning of the antenna / feedline combination the power output will change, distortion may occur and the transmitter may overheat.
ATUs are a standard part of almost all radio transmitters; they may be a circuit included inside the transmitter itself or a separate piece of equipment connected between the transmitter and the antenna. In transmitters in which the antenna is mounted separate from the transmitter and connected to it by a transmission line (feedline), there may be a second ATU (or matching network) at the antenna to match the impedance of the antenna to the transmission line.
In low power transmitters with permanently attached antennas, such as cell phones and walkie-talkies, the internal ATU is set to work at the standard operating frequency with the standard antenna, and is typically only factory adjusted. In high power transmitters, like commercial or amateur radio stations, the ATU is regularly re‑adjusted to accommodate changes in the transmit frequency, or antenna, or transmitter, and there can be several ATUs used in a single transmitting system, all adjusted in combination. Re‑adjusting each ATU to match the transmitter to the antenna at the transmit frequency is an important procedure done after any change to the system components has occurred. This adjustment is done using one of a variety of simple to advanced instruments to measure transmission performance, such as ammeters, SWR meters, antenna analyzers, and remote signal strength meters, among others.
In radio receivers ATUs are not so important, because in the lower-frequency parts of the radio spectrum the signal to noise ratio (SNR) is dominated by atmospheric noise. It does not matter if the impedance of the antenna and receiver are mismatched so some of the incoming power from the antenna is reflected and does not reach the receiver, because the signal can be amplified to make up for it. However, in high frequency receivers the receiver's SNR is dominated by noise in the receiver's front end, so it is important that the receiving antenna is impedance-matched to the receiver to give maximum signal amplitude in the front end stages, to overcome the internally created noise.