Slot 1

Slot 1
TypeSlot
Chip form factors
Contacts242
FSB protocolAGTL+
FSB frequency66, 100, and (on third-party chipsets) 133 MHz
Voltage range1.3 to 3.50 V
ProcessorsPentium II: 233–450 MHz

Celeron: 266–433 MHz
Pentium III: 450 MHz–1.13 GHz
(A Slotket makes following Socket 370 CPUs usable:
Celeron and Pentium III to 1,400 MHz,
VIA Cyrix III: 350–733 MHz,
VIA C3: 733–1,200 MHz

Slotkets also made it possible to use some Pentium Pro CPUs for Socket 8 using the same method.)
PredecessorSocket 7
SuccessorSocket 370

This article is part of the CPU socket series

Slot 1 refers to the physical and electrical specification for the connector used by some of Intel's P6 microarchitecture processors, including the Pentium Pro, Celeron, Pentium II and the Pentium III. Both single and dual processor configurations were implemented.

A Slot A CPU on the left compared to a Slot 1 CPU (connector rotated by 180 degrees)

The form factor used for Slot 1 was a 5-inch-long, 242-contact edge connector named SC242. To prevent the cartridge from being inserted the wrong way, the slot was keyed to allow installation in only one direction. SC242 was also used for AMD's Slot A for early versions of their Athlon CPUs, though while the two slots were identical mechanically, they were electrically incompatible. To discourage Slot A users from accidentally installing a Slot 1 CPU on a Slot A motherboard, the connector was rotated 180 degrees. This also allowed motherboard manufacturers to save costs by stocking the same part for both Slot 1 and Slot A assemblies.

Intel went back into using a traditional socket interface with Socket 370 in 1999.