Renard series

The Renard series is a system of preferred numbers dividing an interval from 1 to 10 into 5, 10, 20, or 40 steps. The preferred values are rounded forms of a geometric sequence and can be extended above or below this interval by multiplication or division by powers of ten.

The system is named after the French army engineer Colonel Charles Renard, who developed a system of preferred values during the late nineteenth century. It was later adopted for international standardization and became the basis of ISO Recommendation R3, first published in the 1950s and subsequently superseded by ISO 3.

The factor between consecutive Renard numbers is constant: it is the fifth, 10th, 20th, or 40th root of 10 for the R5, R10, R20, and R40 series, respectively. Since their exact theoretical values are all irrational, they are rounded when used in practice.

The resulting spacing allows a range of sizes to be covered while limiting the number of values that must be standardized, manufactured, or stocked. Renard values have been used for engineering dimensions and ratings, including electrical-component ratings such as fuse currents and capacitor voltages.

Comparison of preferred numbers of the 1–2–5, Renard and f-stop series on a logarithmic scale divided into 40 equal intervals (blue)