Pontiac 301 Turbo
| Overview | |
|---|---|
| Manufacturer | Pontiac |
| Production | 1980–1981 |
| Layout | |
| Configuration | V8 |
| Valvetrain | Overhead valve |
| Chronology | |
| Predecessor | 301.6 cu in (4.9 L) Pontiac 301 |
The Pontiac 301 Turbo (RPO LU8) is an engine that Pontiac produced for the 1980 and 1981 Pontiac Firebird. It was derivative of the 301cu Pontiac V8 that differed slightly from the traditional design of the Pontiac V8 family. While the Pontiac 301 had already been in production since 1977, the inclusion of Forced Induction was not implemented until the 301 Turbo development began in 1978. Pontiac had already discontinued their 455 in 1976 due to the tightening emissions mandates for manufacturers, and production for the 6.6L engines such as their 400cu engines and the Oldsmobile sourced 403 was beginning to wind down as the CAFE requirements increased. Pontiac Firebird Pontiac sought to find a solution to the lack of performance engine options available, as GM was pushing for Pontiac to utilize the already existing Chevrolet 305 5.0L V8 as part of their corporatization of their brands for cost cutting measures. Pontiac only had the 301 platform still in production, and they intended on refusing to use Chevrolet drivelines for as long as they were able. Considering the limitations of the 301 for raw perofrmance, they sough to increase performance through an exhaust-driven turbocharging system. One of the General Motors Institute (GMI) professors, Jim Lyons, was brought on by Pontiac to assist in the development of the turbocharged set up for the Firebird. Pontiac's chief engineer of induction, emissions, and exhaust Leo Hilke worked on designing the 301 Turbo for mass production. His team had found it significantly more difficult to engineer the turbocharging set up contrasted to the high performance Ram Air engines such as the 303 they had worked on previously, but when given the ultimatum of either using Chevrolet's drivelines or continuing to develop the 301 Turbo, they persevered, and the 301T reached a point in which it was optimized for efficiency and met the strict emissions requirements. A 1980 Turbo Trans Am was tested by Hot Rod Magazine in March of 1980 and was able to achieve a 16.30 second quarter mile time, while comparatively the 1980 Chevrolet Camaro equipped with the Small-Block Chevrolet 5.7L 350cu LM1 and a 4-speed manual completed the quarter mile in 16.40 seconds in a test by Car and Driver in April of 1980.
The 301 Turbo finally met production and was first added to the Pontiac model line-up in 1979 as an available driveline option for the 1980 model year, making the first production Pontiac V8 engine to use forced induction. It was only available for the 1980 and 1981 model years, which were also the last two years of this body style of the Firebird before it was succeeded by the all-new third-generation F-body in 1982. The 301 Turbo was intended to continue onto the third generation platform, however General Motors ceased the production of the engine as part of the corporatization of GM's engine development. 1982-84 Pontiac Firebirds featured a bulge in the hood as seen in the 1980-81 Turbo-equipped Firebirds as the platform was designed to include the 301 Turbo as an engine option. While the Turbo hood was still manufactured and featured on the third generation Firebird, GM pulled the 301 Turbo from the line up before the model went into production.