National Semiconductor SC/MP

National Semiconductor SC/MP
PMOS SC/MP (ISP-8A/500)
General information
LaunchedApril 1976 (April 1976)
Common manufacturer
Performance
Max. CPU clock rate1 MHz to 4 MHz
Data width8 bits
Address width16 bits
Physical specifications
Package
Architecture and classification
Number of instructions46
History
SuccessorsSC/MP-II (INS8060)
70-Series (INS807x)

National Semiconductor's SC/MP (pronounced scamp) for Simple Cost-effective Micro Processor, is an early 8-bit microprocessor which became available in April 1976. It was designed to allow systems to be implemented with the minimum number of additional support chips. SC/MP included bus-access control signals that allowed several processors to share a common memory bus in a daisy-chained multiprocessor arrangement, or to support direct memory access hardware.

The SC/MP was followed by the SC/MP-II, also known as the INS8060. National Semiconductor later introduced the 70-Series (also known as the INS8070 Series). Some later sources refer to this family as “SC/MP III” or “SC/MP-3”, terminology not used in contemporary National Semiconductor documentation.

The programmer-visible model comprises an 8-bit accumulator, an 8-bit extension register, an 8-bit status register, and four 16-bit pointer registers, one of which is used as the program counter. Memory-reference addressing is page-based, with address arithmetic performed on the low 12 bits of the address.

Designed to be as low-cost as possible, the SC/MP emphasized simple control logic and built-in multiprocessor bus arbitration. It is significantly slower than contemporary designs like the Intel 8080 or MOS 6502. Another oddity was that the program counter could only increment the lower 12-bits of the 16-bit address; the upper 4-bits had to be set using special instructions. The result was that instructions accessed main memory as sixteen 4 KB "pages" and reaching memory outside those pages required multiple instructions.

The combination of slow speed and paged memory limited its attractiveness outside the embedded markets it was aimed at, and in this market it competed against the Fairchild F8 which had a number of useful additional features and cost less than a dollar more at 100-unit quantities. The system saw relatively little use. Signetics was identified as an authorized second source and published SC/MP-II documentation, but it is unclear whether it manufactured any SC/MP devices.